_hot_: What To Do If Insinkerator Stopped Working

The search results also mentioned a hex hole at the bottom center of the unit. She found an Allen wrench (often taped to the disposal itself or in the junk drawer). Tom inserted it into the hole and cranked it back and forth. Crunch. Clunk. A rogue olive pit tumbled free inside.

The InSinkErator roared to life, louder than usual for three seconds, then settled into its normal hum. Maria grinned. what to do if insinkerator stopped working

After turning the wrench, Maria pressed the little red button one more time. Then she flipped the wall switch. The search results also mentioned a hex hole

She ran cold tap water for 30 seconds to flush out any remaining debris. Then she fed a few ice cubes down the running disposal—a trick she’d just learned from the same article—to clean the blades. Crunch

Before you call a plumber or buy a new unit, look under the sink for the red reset button. If that doesn’t work, use the hex wrench to free a jam. Nine times out of ten, you’ll fix it in under five minutes.

Her husband, Tom, looked up from setting the table. “Did you blow a fuse?”